I think the aeotec multi sensor claims to be ip66 rated but reviews on outside use seem to be pretty bad.
Z wave door sensor reddit.
I have a bunch of the monoprice z wave recessed door sensors and a few of their z wave controlled outlets all running hassio on a pi 3 and an aotec z wave stick.
Also interested in this.
I recently purchased a used cheap 40 kwikset deadbolt that is supposed to be z wave compatible.
I tried with a 433mhz door sensor but i felt the connection was just a bit too unreliable at range so instead i ordered a z wave me razberry card since it said it had a 200m range and a telldus magnetic switch sensor.
They regularly recognize make break events and trigger accordingly.
I know zero about it.
99 sure these monoprice no name sensors are the same linear made sensors sold under gocontrol and another name.
There don t seem to be any options when you d think it would be a no brainer.
The deadbolt does not have a keypad.
You might need to use another z wave device as a repeater z wave is a mesh network after all if the distance is pretty far away.
Is it possible that the hub and the sensor are too far apart.
I also purchased the gocontrol pack of two door window sensors plus motion sensor for 40 something on amazon.
Op asked about the new z wave plus sensors not currently compatible with wink.
For a while everything was working fine.
I m using the older version.
I am a z wave noob.
Outdoor z wave motion sensors are as elusive as z wave canopy fan controllers.